5Pcs LED Strip Connectors for SMD 5050 RGB Strips

The 4-pin connector is suitable for use with RGB 5050 LED strips. The LED strip width is 10mm.

Installation Instructions: 1. Open the clip on the side of the connector. 2. Slide the 10mm LED light strip inside the clip, underneath the two contact prongs. 3. Ensure the side of the strip aligns with the "+ -" polarity. 4. Close the wire clip.

Package Included: 5 x 4-pin LED strip connectors

Note: 1. When quickly pressing down the connector with pliers, ensure the pins will pierce the 4 copper pads on the FPCB. 2. Quickly press on each side of the connector with pliers. Under the impact force, the wire-end blade will go through the insulation skin to contact the conductor, then begin functioning. 3. Turn off the power before cutting and reattaching light strips.

These 4-pin connectors are compatible with both waterproof and non-waterproof 5V, 12V, and 24V LED strips up to 5A (R, G, B 3 channel) capacity, allowing you to connect longer LED strips using a single connector.

Simply slide the light strip under the connector's pins and snap the clip. (Tip: Do not pry up the metal pins, as this may cause poor contact.)

Regardless of the order of the RGB+ markings on the connectors, the connection will work as long as the "+" and "-" of the light strips on both sides are aligned.

Note: Ensure you place the LED strip under the pins, not on top. When installing waterproof LED strips, please peel off the silicon around the soldering area. Also, be sure to cut along the suggested line evenly to allow for proper connection on each side.

These 4-pin LED connectors are suitable for both indoor and outdoor use, making them a versatile solution for a variety of lighting applications.

product information: