LED Strip Connectors for Multicolor RGB LED Strips

The I-shaped LED strip light connector is suitable for RGB 5050 LED strip lights with a width of 10mm (4-PIN). To use it, follow these steps:

1. Open the I-shaped connector.
2. Insert the light-emitting diode strip light under the metal pins, ensuring the metal pins touch the contact points. If your LED strip is a waterproof drip strip, please peel off the silicon from the surface around the soldering area before use.
3. Close the wire clip, making sure the side of the strip aligns with the "+ -" polarity.

Note: 1. Ensure the pins will pierce 4 copper pads on the FPCB when you quickly press down the connector with a pliers. 2. Make sure to quickly press on each side of the connector with a pliers. Under the impact force, the wire-end blade will go through the insulation skin to contact the conductor, then start its work. 3. Turn off the power before cutting and reattaching light strips.

The package includes 12 x 4-pin LED strip connectors. These flex LED strip connectors, 10mm wide, can connect two RGB 5050 flex strip lights and strip segments.

The LED strip connectors can connect to any 5-24V low-voltage power supply, and any length of light strip can be cut to facilitate the connection, providing a fast and safe connection.

The LED strip light connectors are suitable for both waterproof and non-waterproof light strips. If your LED strip is a waterproof drip strip, please peel the silicon from the surface around the soldering area before use.

To use the connector, simply slide the light strip under the connector's pins and snap the clip. (Tip: Please do not pry up the metal pins, as doing so may cause poor contact.)

The 4-pin connector can enable diversification in the installation of the light strip, allowing multi-angle extension connection, and solving the installation limitations of the light strip placement location. Be sure to cut along the suggested line evenly so there is room for a proper connection on each side.

product information: